|
|
Timing Belt Tensioner (pulley) - Ina 5310311100 Volvo.
Timing Belt Tensioner Pulley For Any 03-05 S80 6cyl (turbo Or Non-turbo) Xc90 T-6 03-05 All. Ina In A Febi Box.
Manufacturer: Ina
ID: 5310311100
Category: Engine Timing
SKU: 9084
|
|
|
Seat Side Cover Set - Front (black) - Genuine Bmw 52107058008.
1 Set Of Front Seat Lower Switch Cover Set For Cars With A Black Interior. Includes 1 Drivers Side Cover And 1 Passenger Side Cover.
Manufacturer: Genuine Bmw
ID: 52107058008
Category: Interior Trim , amp, Mechanical
SKU: 31596
|
|
|
Clutch Kit (dual-mass Flywheel Conversion) (228mm) - Valeo 52255602 Vw.
Complete Dual To Single Mass Clutch Kit Includes Flywheel With Bolts Clutch Disc Release Bearing Pressure Plate With Bolts And Alignment Tool.
Manufacturer: Valeo
ID: 52255602
Category: Clutch
SKU: 37966
|
|
|
Rod Bearing Set (std) - Proparts 21430136 Volvo 270136.
Standard Rod Bearing Set For Any 85-95 240/700/900 B230/b234/b230 Turbo All. Volvo Original Glyco/federal Mogul.
Manufacturer: Proparts
ID: 21430136
Category: Engine Mechanical
SKU: 39566
|
|
|
Disc Brake Caliper Hardware Kit - Rear - Proparts 51992230 Saab 5239744.
Rear Saab Disc Brake Hardware Kit For Any 94-98 900 9-3 All 9-5 Up To Mid 99 (to Vin # X3025751). 1 Kit Per Car.
Manufacturer: Proparts
ID: 51992230
Category: Rear Brakes
SKU: 39837
|
|
|
Engine Oil Filter - Mann-filter Hu9263x Bmw 11421730389.
Oil Filter Kit (includes Filt Er Drain Plug Seal Metal Seal Ring Housing Seal And O-ring) For Any 325i/is/ic (e36) 525i/it (e34).
Manufacturer: Mann-filter
ID: Hu9263x
Category: Filters
SKU: 41278
|
|
|
Shock Absorber - Front (sport) - Sachs 170813 Audi 3b0413031h.
Front Shock Absorber For Audi A4 A4 Quattro A6 A6 Quattro S4 S6 And Volkswagen Passat. Sport Suspension Only.
Manufacturer: Sachs
ID: 170813
Category: Front Suspension
SKU: 65464
|
|
|
Exhaust System Kit (cat-back) (performance) - Mototec Mtesa951 Saab.
Single 2.5in Piping Single Oval 90/120mm Rolled Tip Constructed From T409 Stainless Steel Tubing And Black Coated Muffler.
Manufacturer: Mototec
ID: Mtesa951
Category: Exhaust System
SKU: 79616
|
|
|
Engine Air Intake Kit (performance) - Dinan D7600011 Bmw.
The Dinan High Flow Performance Intake Kit Uses A Replacement Air Box Lid Which Is Engineered To Increase Air Volume And House A Larger High Flowing Air Filter. The Air Box Lid Is Made Of A Composite Material Able To Shield Engine Heat From Affecting The Incoming Air Stream. Also Included Is An Additional Ram-air Intake Duct To Provide A Cooler And Denser Air Charge For The Intake. Can Be Installed With Or Without The Ra M Air Duct. Expected Power Gains Of 8hp @ 6500 Rpm And 7lb-ft Of Torque @ 6500 Rpm.
Manufacturer: Dinan
ID: D7600011
Category: Other
SKU: 164162
|
|
|
Coilover Kit (adjustable) (non-edc) - Dinan R1909134 Bmw.
The Dinan Performance Coilover Kit Utilizes The Factory Non Electronic Damper Control Shocks And Provides The User With Performance Lowering Springs. Ride Height Is Adjusted Up To 1 Inch Using The Billet Threaded Collars. The Beehive Shaped Front Springs Low Profile Camber Plates And Progressive Bump Stops Allow The 335i To Maintain Stock Suspension Travel While Being Lowered. The Strut Mounts Are Made From 6061-t6 Aluminum And Incorporate Heavy Duty Rubber And Delran Components For Increased Performance And Quiet Operation. This Kit Allows For Camber Adjustments B Etween -1.2 And -3.2 Degrees. Lastly Dinan Includes Suspension Packers Which Allow The User To Adjust Bump Stop Clearance. All Of The Components In The Kit Are Compatible With 2.50 Inside Diameter Racing Springs. *not For Models With Edc (electronic Damper Control).
Manufacturer: Dinan
ID: R1909134
Category: Rear Suspension
SKU: 164184
|
|
|