Rear Subframe Mount Bushing (passenger Side Front Position). 1 Per Car.

Front Swaybar Link Washer For Any 240 700 900 Through 93. 95-98 960 S/v90 Rear Swaybar Link Washer. 4 Per Car.

Flame Trap Coupler (hose) For Any 850 Non-turbo 95-97 Automatic. Connects Flame Trap To Breather Pipe.

Stanchion Arm Bushing Sleeve For Any 900 94-98 9-3 99-02 (and 03 Convertible). 2 Per Bushing 4 Per Car.

Camshaft Position Sensor For Any S80 02-06 S60 02-08 V70/xc70 02-07 C70 02-04 Xc90 5cyl All 6cyl 03-06 V8 05.

Front Spring For Any 9-5 Aero With Suspension Code Ga (spring Marked With Orange/blue Paint). 2 Per Car.

Drivers Side Front Upper Control Arm (aka Traction Strut) With Bushing. 1 Per Car. Use With (1) Hex Bolt 07 11 9 900 224 (to Sub Frame) And (1) Locking Nut 33 30 6 760 349.

Front Axle Outer C/v Boot Kit. Includes (1) Boot (1) Tube Grease Retaining Clips. 2 Kits Per Vehicle.

Fuel Pump Assembly With Level And Pressure Sensors For Any 9-3 03-09 4cyl. Genuine Saab Pump In A Ti Automotive Box Formerly Known As Walbro.

Set Of Rear Brake Pads With Wear Sensor. Genuine Bmw Service Kit For Brake Pads. 318i Convertible/318is Coupe (e36).

Weve Been Working Hard To Make The Plug-in T5 Upgrade For A Classic 900 A Reality. The First Major Step Is Getting A Solid Crank Position Sensor Signal So T5 Can Do Its Magic. This Cnc Machined Flywheel Has The Correct 60-2 Tooth Pattern Relieved Out Of The Back Section So That The Sensor Can Be Easily Mounted Under The Starter Plate. Dead Accurate And Reliable We Have Tested This Product In Multiple Motorsports Applications As Well As Everyday Drivers. As An Added Bonus If You Have An Early 900 Turbo Or Non-turbo Flywheel We Add The Later 900t Clutch Pattern To Use The Standard 220mm Or 228mm Upgrade Clutch Kit. Secondly Weve Created A Custom Crank Position Sensor (cps) Bracket Kit. Beautifully Crafted Out Of Aluminum It Includes Everything You Need To Bolt To Your Classic 900 And Get On With Your Trionic Conversion. No Cutting Or Drilling Required This Product Mounts To The Block With Clear Access And Easy Crank Position Sensor Adjustability. The Cps Is Not Included But If You Need One Use Part 422703a Or 0261210030 Lastly In The Kit Weve Included A Quality Piliot Bearing. For Even More Performance Check Out Our Lightened Flywheel Which Removes Weight From The Outer Edge Reducing Rotational Mass And Increasing Throttle Response And Acceleration. Does Not Adversely Affect Drive-ability. Flywheel Comes Sandblasted But Not Resurfaced.

Direct Fit Performance Air Intake Kit. The 4 Inch High Flow Air Filter Eliminates The Restrictive 3 Inch Inlet In The Stock Air Intake System. The Black Powder-coated Aluminum Airbox Keeps The Incoming Air Cool From The Engine Heat. The Airbox Retains A Stock Looking Appearance And Is Designed To Work With The Stock Air Inlet Duct. The Mishimoto High Flow Air Filter Is Reusable And Can Be Cleaned And Re-oiled. Includes A Silicone Intake Hose Hose Coupler Clamps And Hardware.

A Machined Aluminum Joiner To Replace That Rusty Eyesore On Your Otherwise Restored Engine Bay.m Ade In Usa

Timing Chain For Any 79-88 900 8 Valve. No Master Link (open Chain) Saab Original Iwis.

Serpentine Belt Tensioner For Any 900 V6 9000 V6 99-03 9-5 V6. Includes Pulley.

Heated Seat Pad (backrest) For The Front Seats Of Any 900 94-98. 1 Per Seat.

Rear Crankshaft Oil Seal. 100 X 125 X 13 Size Seal. 1 Per Car.

Front Window Regulator Retaining Clip. 1 Per Regulator 2 Per Sav.

Passenger Side Inner Ball Joint For The Front Lower Ascendency Arm. 1 Per Car.

Drivers Side Front Fender Wheel Well Liner For Any 900 94-98 9-3 99-02 & 03 Convertible.

Bearing Housing For Front Of Engine Balance Shaft. 2 Per Car

Single Piston Caliper. Disc Brake Caliper Passenger Side For Bmw (750i 750il 1 Piston Caliper)

Star Hood Emblem. Genuine Mercedes-benz. Enamel Cloor Blue

Impact Strip For Front Bumper On The Passenger Side Corner For My2001+ E39.

Light Bulb Set (hb7) (12v 100w) (optilux Extreme White)