Upper Thermostat Housing For Any 93-97 850 S/v/c 70 98 Only.

Lower Radiator Hose Lower Half For 88 -93 900 Turbo Automatic With An In-line Oil Cooler. Replaces Old Part #7548829.

3 Piece Clutch Kit Includes Pressure Plate Clutch Discpilot Bearing And Release Bearing. ***see Tech Note Before Ordering****

Electronic Throttle Body For Any 9-3 4cyl 03-06. Use With (1) 90537718 Throttle Body Gasket (not Included). This Part Requires A Software Update Through A Dealer After Installation Or It Will Not Function Properly.

Hd Aluminum; Parking Lever; 5mm Pivot W/shim Kit *note: There Are 2 Styles Of Shift Park Levers Which Are Differentiated By The Width Of The Hinge Pivot Base. Either A 5mm Or An 11mm Base Maybe Fitted. This Is A Running Change And Not Defined By A Specific Year Or Chassis. A Quick Inspection Of The Existing Plastic Lever In The Shifter Maybe Required Before Ordering The Correct Part.

Copper Sealing Ring For Genuine Volvo Models. 16mm Id. Typically Used In Banjo Fittings Egr Systems And Engine Block And Head Plugs.

Motor Oil Saver By Lubro-moly Rejuvenates Rubber And Plastic Engine Seals And Reduces Oil Consumption Via The Piston Rings And Valve Guides;counteracts The Loss In Viscosity Of Motor Oils. Puts An End To Environmentally Pollutant Oil Patches On The Road And In The Garage. Prevents Blue Smoky Exhaust Fumes. Prevents Leaks Due To Leaks At Elasto-meric Seals. Regenerates Engine Seals Made Of Plastic And Rubber. Reduces Engine Noises. Prevents Pollution Of The Environment Due To Oil Dripping From The Engine. Reduces Oil Consumption In Gasoline And Diesel Engines.

Kit Includes Timing Belt Timing Belt Tensioner Timing Belt Idler Pulley Water Pump Water Pump Gasket And Camshaft Seals.

The Oil Catch Can Separates The Engine Oil From The Crankcase Gases Which Gets Rerouted Into The Intake Stream. This Helps To Stop Oil Loss And Aids In Keeping The Intake Valves Clean On Didect Injection Engines. It Will Prevent Oil From Getting Into Pressurized Turbo Tubing And Prevents Oil Vapors From Entering The Intake Stream. Made From Anodized 6061 Lightweight Aluminum This Catch Can Kit Includes A Mounting Bracket Hoses Clamps And Hardware. The 40-micron Bronze Filter And Internal Baffle Prevents Oil From Entering The Intake. Inlet And Outlet Ports Accept An Fittings. The Drain Plug Can Be Replaced With An An Fitting And Hose To Allow For A Custom Line To Be Made To Drain The Excess Oil To The Oil Pan.this Catch Can Can Be Cleaned And Reused.

Opens At 158 Fahrenheit / 70 Celsius. Vehicle Must Be Equipped With The Stock Plastic Thermostat Housing In Order To Install This Part. The Metal Pin Must Be Removed From The Mishimoto Thermostat Before Installation.

Service Manual: 89-90 9000; Electrical System & Wiring Diagrams With Fault Tracing

Neutral Safety Switch (range Switch) For Any 900 96-98 Automatic 9-3 99-02 Automatic. Genuine Saab.

Front Strut Mount For 2002 - 2009 9-5 (2 Per Car).

Crankcase Vent Hose That Exits Oil Trap For Any 00-03 9-3/9-5 (4cyl). Pcv Valve Not Included.

Crankshaft Pulley Housing For Any 900 4cyl 94-98 9-3 99-02(and 03 Convertible) 9-5 4cyl 99-07.

Headlight Assembly Shock Absorber. 1 Per Headlight 2 Per Car.

Rubber Insert For Wiper Frames Length Can Be Trimmed To Fit.

Fuel Fitting With Barb For 200 Series 75-93 700 Series 88-91 900 Series 91-93

Gasket For Pcv Connector On Side Of Valve Cover. 1 Per Car.

For Solid Rear Rotors And Electronic Parking Brake Vehicles

Brake Caliper Pin Kit For Brembo Big Brake Upgrade . Will Not Fit Regular Cars With Stock Hardware.

Does Not Include Control Units Xenon Bulb Or Turn Signal Insert.

Black Square Profile For Vehicles Without Roof Rails (5 Door)

Foglight Assembly - Passenger Side (w/ Adaptive Headlight) (nsf)

Engine Coolant Reservoir Hose (bottom) (expansion Tank To Pipe)